The Wright Rocket Site

Tomahawk Project - Page 3

On to the avionics bay!  For the Tomahawk I was able to procure a small segment of airframe to glue into the center of the bay and use for switch access.  It's nice and easy working with this G-10 vs. other materials.

In order to provide attachment points for the screws that will hold the bay to the payload section and as a shelf for the electronics sled I used 1/2"x3/4" trim that I epoxied into place.

We then drilled through the airframe and av-bay and used t-nuts on the inside to secure the assembly.  This worked out really well!

Final epoxying of the fore centering ring. 

Other than finishing the electronics sled and assembling the recovering harness the construction for this bird is done!  Ready to paint almost!